Radio Engineering Industries Digital BUS-WATCH R4001 Instrukcja Obsługi Pobierz pdf (Strona 46)

Digital BUS-WATCH

PC Software Manual

Radio Engineering Industries, Inc.

640372 - Rev C - 11/10/2009

Page 46 of 75

I-Frame: Set this to Y on DVRs that will be connected through a cell phone

tower network. The DVR will record all video but send back only

the I-Frames

Channel Name: Descriptive display name for each channel (camera) of this DVR

(Optional – can be left blank)

* Note: The values in the IP address (Addr) and port fields must match the settings of the

target DVR. Please contact your IT administrator and/or consult the DVR hardware

manual for information on DVR IP address and port settings.

To create an entry for a DVR within an existing group

• Select the desired group

• Click the Add Button located below the DVR entry pane.

• The DVR (Base) Info dialog box will appear.

• After the required information has been successfully entered

• Click OK to accept the information to create an entry for the DVR within the

currently selected group

• Cancel to discard the information and skip entry creation.

• Focus will return to the Devices tab.

A list of DVR entries within the currently selected group appears in the DVR entry pane.

To edit the DVR information for an entry

• Select the entry from the DVR entry list

• Click the Edit Button located below the DVR entry pane.

• The DVR Info dialog box will reopen. Edit the information contained in the

fields, as necessary.

• Click OK to accept the new information.

To delete a DVR entry

• Select the entry and click the DEL Button located below the DVR entry pane.

• The selected entry will be deleted. All information contained in the deleted entry

will be lost.

System

The System tab includes additional configuration parameters for the Digital BUS-

WATCH® surveillance system. The settings included on the System tab should not be

changed, and should remain set to default values, unless instructed otherwise by technical

support personnel.

By default, there should be a check mark on the C: within the Record Capture Drivers

Box. If there is not a check mark, the capture functions are disabled. Once checked, this

will be the default location where video files are stored when the Record Button

Function is enabled. Please see page 17 for greater detail about this option. When the

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 74 75

Brak uwag

Radio Engineering Industries Digital BUS-WATCH R4001 Instrukcja Obsługi Strona 46